Sportbike Rider Picture Website
|More Information on the Honda RCV MotoGP Models|
The Honda RC211V is a four-stroke race motorcycle from HRC (Honda Racing Corporation) developed in 2001 to replace the two-stroke Honda NSR500.
It was developed as a direct result of major changes to the regulations for the World Championship motorcycle road racing 500 cc (30.5 cu in) class for the 2002 season. The name of the class was modified to MotoGP, and while two-stroke engines remained limited to 500 cc (30.5 cu in) and 4 cylinders, four-stroke engines were now allowed to be as large as 990 cc (60 cu in) and from three to six cylinders – which led many teams to switch to four-stroke designs.
The model name designates the following:
The RC211V was replaced in 2007 by the RC212V.
In 2002, the debut year of the RC211V, Honda and Valentino Rossi dominated by winning the constructors' championship by more than 100 points over their nearest rival. The bike underwent small modifications over the season, but it did not as yet have traction control so much as a handlebar-mounted power management system with 3 settings for different needs during a race.
Among other changes in 2003, power was increased from about 200 to 240 bhp. Traction control was also added.
For 2004, a new, inverted rear suspension link was added, and a new exhaust was introduced at the Sachsenring round. The RC211V riders were unable to keep Rossi (now on a Yamaha YZR-M1) from winning his fourth premier-class championship, and no clear candidate appeared to take over Rossi's role of lead development rider for Honda.
2005 would be the first time in 4 years Honda lost the constructors' championship in the premier class. The RC211V chassis underwent frequent revision and rewelding, with reversions to the 2003 design. After the race at Brno, Honda tested a new bike which both Hayden and Biaggi said was an improvement, and was thereafter known as the "Brno bike".
In 2006, the RC211V came in three flavors: the "Brno bike" to be ridden by Hayden, a 2006 bike with a special chassis for Pedrosa, and a 2006 bike to be ridden by Melandri, Elías, Stoner and Tamada; Melandri and Stoner eventually got the special Pedrosa chassis. Hayden's RC211V was modified to put the crankshaft higher, the clutch and gearbox lower, and to lengthen the swing arm; the goal was to centralize mass and improve stability. After the Jerez round, Hayden was the fastest Honda rider in testing. At the British GP, HRC gave Hayden a new chassis, but Hayden complained that he didn't have enough time to test it. Hayden had started the year with the same clutch as Pedrosa, but four rounds later it was shelved in favor of a clutch Hayden had used in previous years; at the Brno round, he had a problem with the clutch that contributed to a 9th-place finish. Honda and Hayden had difficulty finding a clutch that would allow a good launch at the start but also work well throughout the race. Hayden eventually won the rider championship and Honda reclaimed the constructors' championship.
The RC211V was retired when rules dictated a switch to 800 cc (49 cu in) capacity; Honda's bike for 2007 was the RC212V.
In 5 seasons of MotoGP racing the Honda RC211V won 48 races out of 82 (58.5%) contested. It also won 3 rider world championships (Rossi 2002, 2003 and Hayden 2006) and 4 constructor titles (2002, 2003, 2004, 2006).
Specifications as per manufacturer:
Complete MotoGP results
(key) (results in bold indicate pole position; results in italics indicate fastest lap) (the teams are bold indicate factory teams; the riders are bold indicate the rider rode a factory bikes in the satellite teams)
The photo 2008-Honda-RCV-MotoGP-Models-342363-GP.jpg (2008 Honda RCV MotoGP Models - Uploaded for: waldemar krzyzanowski
2008 Honda RC211VV5) was uploaded by: [email protected]
Please note, we do not have accessories, motorbikes, motor cycles, motorcycles, or motorcycle gear for sale. This site is dedicated to displaying bike images of Aprilia, Bimota, Harley Davidson, Honda, Kawasaki, Suzuki, Triumph, Yamaha, and other sportbikes.